Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Installing Lucent™ INTUITY™ System Software
Page 9-6Installing the Lucent I NTUITY System Default Announcement Set and/or Optional
9
4. Press .
The system displays the following message:
Installation in progress. Do not remove the cartridge.
The following sets are available:
1 language x Language Name System Announcements
(AUDIX) R3.x
Select package(s) you wish to process (or ‘all’ to
process all packages). (default: all) [?,??,q]
5. Press .
The system displays following message:
Processing:
(Language Name) System Announcements
(AUDIX) R3.x
Using</> as the package base directory.
Lucent Bell Laboratories
Is this to be the default language set?
(default: y) [y,n,?,q]
6. If you are installing the default language set, enter
y
NOTE:
If you are installing an optional or secondary language set, enter
n
The system displays the following message:
Installation of <optional language name> System
Announcements (VM-<optional language abbreviation>) was
successful.
Insert a cartridge into Tape Drive 1.
Type [go] when ready,
or [q] to quit: (default:go)
7. Enter
q
8. Remove the cartridge tape labeled “System Announcements” from the
tape drive. See “Removing the Cartridge Tape
” in Chapter 3, ‘‘Common
System Procedures’’, for the procedure.
9. Press (Cancel) until the system displays the Lucent I
NTUITY Main Menu
(Figure 9-1
).
ENTER
ENTER
F6