Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Installing Base System Software
Page 8-29Installing the Switch Interface Software Packages
8
Serial-Inband Switch Integration Set
(i486)
Using </> as the package base directory.
The following types of host switches are available.
They are:
1) NEC NEAX
2) Siemans HICOM
3) Ericsson MD110
4) Merlin Legend
5) DMS100
6) Intecom
7) Norstar
8) System 25
9) 5ESS
10) Definity Mode Code
The system displays several status messages, then the following
message:
Insert a cartridge into Tape Drive 1.
Type [go] when ready
or [q] to quit: (default: go)
7. Enter
q
8. Start the voice system. See “Starting the Voice System
” in Chapter 3,
‘‘Common System Procedures’’,” for the procedure.
Installing the Digital Station Interface
Circuit Card Switch Integration Set
To install the Digital Station Interface Circuit Card Switch Integration set, do the
following:
1. Log in to the system as root.
2. Stop the voice system.
3. Enter
pkgadd -d ctape1
The system displays the following message:
Insert a cartridge into Tape Drive 1.
Type [go] when ready
or [q] to quit: (default: go)
4. Insert the Lucent I
NTUITY Digital Station Switch Integration Set cartridge
tape into the tape drive. See “Inserting the Cartridge Tape
” in Chapter 3,
‘‘Common System Procedures’’,” for the procedure.
5. Press .
The system displays the following message:
ENTER