Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Installing Base System Software
Page 8-28Installing the Switch Interface Software Packages
8
The UNIX Operating kernel will be rebuilt now.
This will take some time. Please wait.
The system responds with a series of memory check displays and
copyright notices. These messages also note that the system is fine and
coming up, the system is ready, and that the voice system is automatically
being started.
This reboot is finished when the system displays the following message:
Startup of the Voice System is complete
Installing the Serial-Inband Switch Integration
Set
To install the Serial-Inband Switch Integration set, do the following:
1. Log in to the system as root.
2. Stop the voice system. See “Stopping the Voice System
” in Chapter 3,
‘‘Common System Procedures’’,” for the procedure.
3. Enter
pkgadd -d ctape1
The system displays the following message:
Insert a cartridge into Tape Drive 1.
Type [go] when ready
or [q] to quit: (default: go)
4. Insert the Lucent I
NTUITY Serial-Inband Switch Integration Set cartridge
tape into the tape drive. See “Inserting the Cartridge Tape
” in Chapter 3,
‘‘Common System Procedures’’,” for the procedure.
5. Press .
The system displays the following message:
Installation in progress. Do not remove the cartridge.
The following sets are available:
1 SWINset Serial-Inband Switch Integration
Set
(;486)
Select package(s) you wish to process (or ‘all’ to
process all packages). (default: all) [?,??,q]
6. Press .
The system displays the following message:
Processing:
Set: Serial-Inband Switch Integration Set (SWINset)
from <ctape1>.
ENTER
ENTER