Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Installing Base System Software
Page 8-27Installing the Switch Interface Software Packages
8
Insert a cartridge into Tape Drive 1.
Type [go] when ready
or [q] to quit: (default: go)
4. Insert the Lucent I
NTUITY DCIU Switch Integration Set cartridge tape into
the tape drive. See “Inserting the Cartridge Tape
” in Chapter 3, ‘‘Common
System Procedures’’,” for the procedure.
5. Press .
The system displays the following message:
Installation in progress. Do not remove the cartridge.
The following sets are available:
1 DCIUset INTUITY Platform DCIU set (V2)
(;486)
Select package(s) you wish to process (or ‘all’ to
process all packages). (default: all) [?,??,q]
6. Press .
The system displays the following message:
Processing:
Set: INTUITY Platform DCIU set (DCIUset) from <ctape1>.
INTUITY Platform DCIU set
(i486)
Using </> as the package base directory.
Select your Intuity DCIU card type:
1) DCIU (Eicon) card [this card has a green LED
on the faceplate]
2) GPSynch card
Enter 1 or 2: [1]
7. Press .
The system displays several status messages, then the following
message:
Insert a cartridge into Tape Drive 1.
Type [go] when ready
or [q] to quit: (default: go)
8. Enter q
9. Enter cd /
10. Enter shutdown -y -g0 -i6
The system displays the following message:
Shutdown started. Date
INIT: New run level: 6
ENTER
ENTER
ENTER