Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Installing Base System Software
Page 8-26Installing the Switch Interface Software Packages
8
The system displays the following message:
Insert a cartridge into Tape Drive 1.
Type [go] when ready
or [q] to quit: (default: go)
8. Enter
q
9. Enter
cd /
10. Enter
shutdown -y -g0 -i6
The system displays the following message:
Shutdown started. Date
INIT: New run level: 6
The UNIX Operating kernel will be rebuilt now.
This will take some time. Please wait.
The system responds with a series of memory check displays and
copyright notices. These messages also note that the system is fine and
coming up, the system is ready, and that the voice system is automatically
being started.
This reboot is finished when the system displays the following message:
Startup of the Voice System is complete
11. Press .
Installing the Switch Interface
Software Packages
There are three switch interface software packages available with the Lucent
I
NTUITY system:
■ DCIU Switch Integration set
■ Serial-Inband Switch Integration set
■ Digital Station Interface Circuit Card Switch Integration set
Installing the DCIU Switch Integration Set
To install the DCIU Switch Integration set, do the following:
1. Log in to the system as root.
2. Stop the voice system.
3. Enter pkgadd -d ctape1
The system displays the following message:
ENTER