Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Installing Base System Software
Page 8-25Installing the Platform Software
8
5. Continue with the next procedure, “Installing the Platform Software.”
Installing the Platform Software
To install the platform software, do the following:
1. Log in to the system as root.
2. Enter
pkgadd -d ctape1
The system displays the following message:
Insert a cartridge into Tape Drive 1.
Type [go] when ready
or [q] to quit: (default: go)
3. Insert the Lucent I
NTUITY Platform AUDIX Set cartridge tape into the tape
drive. See “Inserting the Cartridge Tape
” in Chapter 3, ‘‘Common System
Procedures’’,” for the procedure.
4. Press .
NOTE:
Ignore any messages which indicate that the base ORACLE
package has not been loaded and gives installation procedures.
The system displays the following message:
Installation in progress. Do not remove the cartridge.
The following sets are available:
1 AUDIXset INTUITY Platform AUDIX Set
(;486)
Select package(s) you wish to process (or ‘all’ to
process all packages). (default: all) [?,??,q]
5. Press .
The system displays the following message:
Processing:
Set: Lucent Intuity Platform AUDIX Set (AUDIXset) from
<ctape1>.
Lucent Intuity Platform AUDIX Set
(i486)
Using </> as the package base directory.
Do you want to run default set installation? (default:
y)
6. Press .
The system displays prompts for the craft and tsc passwords.
7. Enter the passwords you want to use for these logins.
ENTER
ENTER
ENTER