Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Installing Base System Software
Page 8-24Running installit
8
Insert a cartridge into Tape Drive 1.
Type [go] when ready,
or [q] to quit: (default: go)
11. Enter
q
12. Remove the Lucent I
NTUITY INTUNIX+e cartridge tape from the tape drive.
See “Removing the Cartridge Tape
” in Chapter 3, ‘‘Common System
Procedures’’,” for the procedure.
13. If your system is using a LAN circuit card, configure the LAN circuit card.
See “Configuring the LAN Circuit Card
” in Chapter 5, ‘‘Replacing or
Installing Circuit Cards’’.”
Running installit
To run installit, do the following:
1. Enter
installit
!
CAUTION:
Make sure the
installit
command and the associated reboots have
been completed prior to continuing with any other procedure.
The system displays the following message:
Installit execution started: <date>
The system will attempt to perform a new installation
Press <ENTER> to continue the Volume Manager
installation
2. Press .
The system is rebooted and then displays the following message:
The UNIX Operating system kernel will be rebuilt now.
The system must now be rebooted to continue the
reconfiguration
Hit RETURN to continue.
3. Press .
The system is rebooted and then displays the following message:
The system must now be rebooted.
Hit RETURN to continue.
4. Press .
The system is rebooted and then displays the following message:
Console Login:
ENTER
ENTER
ENTER