Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Installing Base System Software
Page 8-22Installing the INTUNIX+e Software
8
4. Remove the cartridge tape labeled “Lucent INTUITY UnixWare Image” from
the tape drive. See “Removing the Cartridge Tape
” in Chapter 3,
‘‘Common System Procedures’’,” for the procedure.
5. Continue with the next procedure, “Running installit
.”
Installing the INTUNIX+e Software
To install the INTUNIX+e software, do the following:
1. Verify that the floppy disk drive is empty.
!
CAUTION:
If the floppy disk drive contains a diskette, the system reboot will fail.
If this happens, remove the floppy from the floppy disk drive and
press .
NOTE:
If you are installing the operating system onto a machine that is not
equipped with a LAN circuit card, the system may display a
message that states that an invalid check sum occurred. Ignore this
message.
2. Log in to the system as root.
3. Press at the password prompt.
NOTE:
If the current password has expired, enter
Intuity1
for the password.
Use this password instead of pressing for the remainder of
the procedure. As soon as the Lucent I
NTUITY system tape is
reloaded, you will change this password.
The system displays with the UNIX prompt (#).
4. Enter
pkgadd -d ctape1
The system displays the following message:
Insert a cartridge into Tape Drive 1.
Type [go] when ready
or [q] to quit: (default: go)
5. Insert the Lucent I
NTUITY INTUNIX+e cartridge tape into the tape drive.
See “Inserting the Cartridge Tape
” in Chapter 3, ‘‘Common System
Procedures’’,” for the procedure.
6. Press .
The system displays the following message:
Ctrl-Alt-Del
ENTER
ENTER
ENTER