Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Installing Base System Software
Page 8-17Installing UnixWare
8
4. Press .
The system displays the Hard Disk Surface Analysis screen (Figure 8-14
).
5. Continue with the next procedure, “Performing a Hard Disk Drive Surface
Analysis.”
Figure 8-14. Hard Disk Surface Analysis Screen
Performing a Hard Disk Drive Surface Analysis
!
CAUTION:
Surface analysis is required for all systems because it makes a
configuration change to the disk. Failure to perform surface analysis may
cause the Lucent I
NTUITY system to fail.
To perform a hard disk drive surface analysis, do the following:
1. Starting at the Hard Disk Surface Analysis screen (Figure 8-14
), press
.
This will accept the default of 1 and perform the surface analysis. The
system displays the following message:
Checking the hard disk for defects and creating file
systems. This will take a few minutes. Please wait.
Remove boot floppy 3 of 3 from the drive now.
ENTER
UNIX System Installation Hard Disk Surface Analysis
Surface analysis is recommended but not required. Here you must
choose to skip or perform surface analysis.
Press the ’F1’ or ’?’ key to see more information about these
different system types.
You choices are:
1. Perform surface analysis
2. Skip surface analysis
Press ’1’ or ’2’ followed by ’ENTER’:1
ENTER