Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Installing Base System Software
Page 8-16Installing UnixWare
8
Figure 8-13. UnixWare Installation Set Slice Sizes Screen
Setting the Slice Sizes
To set the slice sizes, do the following:
1. Starting at the UnixWare Installation Set Slice Sizes screen (Figure 8-13
),
use the left and right arrows on your keyboard to move through the
field selections. Use the down arrow to move to the next field.
2. Enter the appropriate number of megabytes of space needed for each
slice as specified in Tab le 8- 1
.
3. Press the down arrow to move to the Apply field.
Table 8-1. Space Requirements for the MAP/5P
Slice
Space
Requirements
(MBytes)
/stand 10
/dev/dump 65
/dev/swap 129
/200
UNIX System Installation Set Slice Sizes
You have selected the MAP/5P system. Now you must specify the sizes
of the filesystem slices. The recommended sizes for a MAP/x system
are provided as defaults on this screen. Press the ’F1’ or ’?’ key
to see more information about these different system types.
Size of /stand in MB: xx
Size of /dev/dump in MB: xx
Size of /dev/swap in MB: xx
Size of / in MB: xx
Apply Reset