Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Installing Base System Software
Page 8-4Installing UnixWare
8
Loading the Host Bus Adapter
To load the host bus adapter, do the following:
1. Insert the diskette labeled “Pentium HBA Floppy” into the floppy disk
drive.
2. Press .
The system displays the following message:
The Host Bus Adapter driver(s) on the Host Bus Adapter
diskette have been loaded and you can now remove the
diskette.
If you have another Host Bus Adapter diskette (for
different adapters) insert that disk now.
For more information, see the UnixWare Installation
Handbook.
Otherwise, if you do not have (or do not need to use)
another Host Bus Adapter diskette, insert the diskette
labeled ‘Boot Floppy 2 of 3’ now.
3. Remove the diskette labeled “Pentium HBA Floppy” from the floppy disk
drive.
4. Continue with the next procedure, “Continuing the UnixWare Installation
.”
Continuing the UnixWare Installation
To continue the UnixWare installation, do the following:
1. Insert the diskette labeled “Unixware for I
NTUITY Boot Floppy 2 of 3” into
the floppy disk drive.
2. Press .
The system displays the Introduction screen (Figure 8-2
).
NOTE:
If the system displays a message that the system must have at least
60 MBytes of space in the hard disk drive to install UNIX, the hard
disk drive is experiencing problems. The cable may not be
connected, or the hard disk drive may be damaged. Power down the
system and check the hard disk drive cables. See “Removing Power
from the MAP/5P” in Chapter 4, ‘‘Getting Inside the Computer’’,” for
the procedure.
ENTER
ENTER