Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Installing Base System Software
Page 8-3Installing UnixWare
8
Figure 8-1. Front View of the MAP/5P
The system displays the UnixWare introduction screen as it begins to load
the base system software. When the system is done with the first boot
floppy it displays the following message:
Remove the diskette labeled ‘Boot Floppy 1 of 3’.
If you have a diskette labeled ‘Host Bus Adapter
Drivers’, insert that diskette now.
For more information on Host Bus Adapter diskettes, see
the UnixWare Installation Handbook.
Otherwise, if you do not have (or do not need to use) a
Host Bus Adapter diskette, insert the diskette labeled
‘Boot Floppy 2 of 3’ now.
Press ‘ENTER’ to continue.
3. Remove Lucent I
NTUITY UNIX Boot Floppy 1 of 3 from the floppy disk drive.
4. Continue with the next procedure, “Loading the Host Bus Adapter
.”
1. Cartridge tape drive
2. Diskette drive
3. Circuit card cage fan
4. Power button
5. Reset button