Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Installing Base System Software
Page 8-2Installing UnixWare
8
Installing UnixWare
Installing the UnixWare operating system unmounts file systems. The
maintenance module in the Lucent™ I
NTUITY™ software has been designed to
detect unmounted file systems and attempt to recover them. If the MTCE module
does not detect any unmounted file systems, all of the software will load.
If this software is being loaded onto a system that has clean hard disks that have
not been previously loaded, the system will not detect file systems.
If this is a recovery installation, the system will detect previously loaded file
systems.
!
CAUTION:
If you use the key to stop the UnixWare installation at any time
during this process, you will have to restart the software installation process
at Step 1.
Preparing the System
To prepare the system, do the following:
1. Verify the CMOS settings. See “Motherboard Installation
” in Chapter 7,
‘‘Replacing Other Components’’.”
2. Verify the SCSI adapter settings. See “SCSI Controller Circuit Card
” in
Chapter 5, ‘‘Replacing or Installing Circuit Cards’’
.”
3. Low level format Hard Disk Drive 0. See “Performing a Low-Level Format
”
in Chapter 6, ‘‘Replacing the Hard Disk Drive’’
.”
4. Continue with the next procedure, “Starting the Unixware Installation
.”
Starting the Unixware Installation
To start the Unixware installation, do the following:
1. Insert the diskette labeled “Lucent I
NTUITY UNIX Boot Floppy 1 of 3” into
the floppy disk drive.
2. If the system is off, turn it on using the power switch on the front of the
MAP/5P (Figure 8-1
).
If the system is on, reboot the system. See “Rebooting the System
” in
Chapter 3, ‘‘Common System Procedures’’
,” for the procedure.
DELETE