Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing Other Components
Page 7-39Riser Card Replacement
7
Restoring the Lucent INTUITY System
To restore the Lucent INTUITY system, do the following:
1. Restore power to the MAP/5P. See “Restoring Power to the MAP/5P
” in
Chapter 4, ‘‘Getting Inside the Computer’’
,” for the procedure.
2. Verify the Lucent I
NTUITY system operation by placing a call to a user.
Riser Card Replacement
!
CAUTION:
Observe proper electrostatic discharge precautions when you handle
computer components. Wear an antistatic wrist strap that touches your bare
skin and connect the strap cable to an earth ground. See “Protecting
against Damage from Electrostatic Discharge” in Chapter 4, ‘‘Getting Inside
the Computer’’.”
The following procedures detail the 6-slot riser card installation and removal. All
of the circuit cards are connected to the riser card. The riser card (Figure 7-14
) is
located in the back of the MAP/5P card cage area. The riser card is connected to
the motherboard.
Riser Card Removal
To remove the riser card, you must:
■ Remove the Lucent INTUITY system from service.
■ Access the riser card.
■ Extract the riser card.
Removing the Lucent INTUITY System from
Service
To remove the Lucent INTUITY system from service, do the following:
1. Verify that the replacement equipment is on site and appears to be in
usable condition, with no obvious shipping damage.
2. Stop the voice system. See “Stopping the Voice System
” in Chapter 3,
‘‘Common System Procedures’’,” for the procedure.
3. Shut down the voice system. See “Shutting Down the Lucent
Intuity
System” in Chapter 3, ‘‘Common System Procedures’’,” for the procedure.
4. Remove the incoming power. See “Removing Power from the MAP/5P
” in
Chapter 4, ‘‘Getting Inside the Computer’’
,” for this procedure.