Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing Other Components
Page 7-36Power Supply Replacement
7
Figure 7-16. Power Supply Switch
8. Remove the screw which holds the grounding wire to the chassis
(Figure 7-16
).
9. Slide the power supply switch out of the retaining slot.
10. Remove the four screws on the chassis rear area that secure the power
supply unit (Figure 7-15
).
11. Slide the unit slightly forward towards the front of the MAP/5P and tilt
towards the riser card.
12. Lift and remove the power supply.
Power Supply Installation
To install the power supply, you must:
■ Insert the power supply.
■ Re-assemble the MAP/5P.
■ Restore the Lucent INTUITY system.
1. Power supply switch retaining screw
2. Power supply grounding wire and screw