Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing Other Components
Page 7-34Power Supply Replacement
7
Removing the Lucent INTUITY System from
Service
To remove the Lucent INTUITY system from service, do the following:
1. Verify that the replacement equipment is on site and appears to be in
usable condition, with no obvious shipping damage.
2. Stop the voice system. See “Stopping the Voice System
” in Chapter 3,
‘‘Common System Procedures’’,” for the procedure.
3. Shut down the voice system. See “Shutting Down the Lucent
Intuity
System” in Chapter 3, ‘‘Common System Procedures’’,” for the procedure.
4. Remove the incoming power. See “Removing Power from the MAP/5P
” in
Chapter 4, ‘‘Getting Inside the Computer’’
,” for this procedure.
Accessing the Power Supply
To access the power supply, remove the dress cover. See “Removing the Dress
Cover” in Chapter 4, ‘‘Getting Inside the Computer’’,” for this procedure.
Extracting the Power Supply
To extract the power supply, do the following:
1. Unplug the connector to the cartridge tape drive (Figure 7-15
).
2. Unplug the connector to the diskette drive (Figure 7-15
).
3. Unplug the connector to Hard Disk Drive 1, if provided
(Figure 7-15
).
4. Unplug the connector to Hard Disk Drive 0 (Figure 7-15
).
5. Unplug both connectors to the motherboard (Figure 7-15
).