Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing Other Components
Page 7-27Motherboard Replacement
7
Inserting the Motherboard
To insert the motherboard, do the following:
1. Place the SIMMs from the defective motherboard on to the replacement
motherboard. See ‘‘SIMM Installation’’ on page 7-21
for the procedure.
2. Place the motherboard in the MAP/5P.
3. Align the external cable connectors on the motherboard with the
corresponding holes in the MAP/5P chassis.
4. Slide the motherboard to the rear of the MAP/5P so that the external cable
connectors protrude through the rear of the unit.
5. Align the holes in the motherboard with the alignment pegs in the MAP/5P
(Figure 7-4
).
6. Gently push the motherboard into the MAP/5P until the retaining bracket
has snapped into place (Figure 7-4
).
7. Attach the diskette cable to the motherboard (Figure 7-4
).
8. Attach the power supply connections to the motherboard (Figure 7-4
).
9. Attach the reset switch connector to CN19 (Figure 7-12
).