Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing Other Components
Page 7-20Memory Replacement
7
4. Replace the circuit cards in the bottom three slots. See
“Installing a Circuit Card
” in Chapter 5, ‘‘Replacing or
Installing Circuit Cards’’.”
5. Replace the dress cover. See “Replacing the Dress Cover
”
in Chapter 4, ‘‘Getting Inside the Computer’’
,” for this
procedure.
6. Restore the incoming power. See “Restoring Power to the
MAP/5P” in Chapter 4, ‘‘Getting Inside the Computer’’,” for
this procedure.
7. Reboot the system. See “Rebooting the System
” in Chapter
3, ‘‘Common System Procedures’’,” for the procedure.
If the system shows an amount of memory less than that installed
on the card, both of the SIMMs should be replaced, continue with
the next procedure, “Extracting the SIMMs
.”
Extracting the SIMMs
To extract the SIMMs, do the following:
1. Release the metal snap locks at the edge of the SIMM2 socket by gently
pushing them to the outside (Figure 7-7
).
Figure 7-7. SIMM Socket
2. Rotate the SIMM downward to approximately a 45-degree angle.
3. Remove the SIMM.
1. SIMM in socket - top view 2. SIMM - side view