Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing Other Components
Page 7-19Memory Replacement
7
3. Shut down the voice system. See “Shutting Down the Lucent Intuity
System” in Chapter 3, ‘‘Common System Procedures’’,” for the procedure.
4. Remove the incoming power. See “Removing Power from the MAP/5P
” in
Chapter 4, ‘‘Getting Inside the Computer’’
,” for this procedure.
Accessing the SIMMs
To access the SIMMs, do the following:
1. Remove the dress cover. See “Removing the Dress Cover
” in Chapter 4,
‘‘Getting Inside the Computer’’,” for this procedure.
2. Remove the circuit cards in the bottom three slots. See “Removing a
Circuit Card” in Chapter 5, ‘‘Replacing or Installing Circuit Cards’’.”
Verifying the SIMM Seating
To verify the SIMM seating, do the following:
1. Apply pressure to both SIMMs to ensure they are properly seated.
2. If both are properly seated, then both should be replaced, continue with
the next procedure, “Extracting the SIMMs
.”
If one or more of the SIMMs are not properly installed or seated, do the
following Steps a through d
:
a. Properly seat the SIMM.
b. Replace the dress cover. See “Replacing the Dress Cover
” in
Chapter 4, ‘‘Getting Inside the Computer’’
,” for this procedure.
c. Restore the incoming power. See “Restoring Power to the MAP/5P
”
in Chapter 4, ‘‘Getting Inside the Computer’’
,” for this procedure.
d. Reboot the system. See “Rebooting the System
” in Chapter 3,
‘‘Common System Procedures’’,” for the procedure.
If the system shows an amount of memory equal to that installed,
the problem has been corrected. Complete the following Steps 1
through 7:
1. Shut down the voice system. See “Shutting Down the Lucent
Intuity System” in Chapter 3, ‘‘Common System
Procedures’’,” for the procedure.
2. Remove the incoming power. See “Removing Power from the
MAP/5P” in Chapter 4, ‘‘Getting Inside the Computer’’,” for
this procedure.
3. Remove the dress cover. See “Removing the Dress Cover
” in
Chapter 4, ‘‘Getting Inside the Computer’’
,” for this
procedure.