Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing Other Components
Page 7-11Diskette Drive Replacement
7
Figure 7-5. Removing the Peripheral Frame
4. Pull the peripheral frame toward you (Figure 7-5
).
The frame will rotate toward the front of the MAP/5P until the bracing lip
has been cleared. At this point you can pull the frame out of the MAP/5P.
5. Locate the screws holding the diskette drive to the peripheral frame.
NOTE:
Pay close attention to the location of the screws in both the
peripheral frame and the diskette drive. If the screws are returned to
a different position, the diskette drive may protrude from the chassis
too far or be recessed into the chassis too much.
6. Holding the rear of the diskette drive, remove these screws.
1. Press down on thumb tab
2. Rotate frame out of chassis