Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing Other Components
Page 7-10Diskette Drive Replacement
7
Removing the Lucent INTUITY System from
Service
To remove the Lucent INTUITY system from service, do the following:
1. Verify that the replacement equipment is on site and appears to be in
usable condition, with no obvious shipping damage.
2. Stop the voice system. See “Stopping the Voice System
” in Chapter 3,
‘‘Common System Procedures’’, for the procedure.
3. Shut down the voice system. See “Shutting Down the Lucent
Intuity
System” in Chapter 3, ‘‘Common System Procedures’’, for the procedure.
4. Remove the incoming power. See “Removing Power from the MAP/5P
” in
Chapter 4, ‘‘Getting Inside the Computer’’
, for this procedure.
Accessing the Diskette Drive
To access the diskette drive, remove the dress cover. See “Removing the Dress
Cover” in Chapter 4, ‘‘Getting Inside the Computer’’, for this procedure.
Extracting the Diskette Drive
To extract the diskette drive, do the following:
1. Remove the diskette cable from the back of the diskette drive.
2. Remove the power cord from the back of the diskette drive.
3. Press down on the thumb-tab which locks the peripheral frame in place
(Figure 7-5
).