Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing Other Components
Page 7-9Diskette Drive Replacement
7
Re-assembling the MAP/5P
To re-assemble the MAP/5P, replace the dress cover. See “Replacing the Dress
Cover” in Chapter 4, ‘‘Getting Inside the Computer’’, for this procedure.
Restoring the Lucent INTUITY System
To restore the Lucent INTUITY system, do the following:
1. Restore power to the MAP/5P. See “Restoring Power to the MAP/5P
” in
Chapter 4, ‘‘Getting Inside the Computer’’
, for the procedure.
2. Verify the Lucent I
NTUITY system operation by placing a call to a user.
Verifying the CMOS Settings
To verify the CMOS settings, see “Inserting the Motherboard” below.
Diskette Drive Replacement
!
CAUTION:
Observe proper electrostatic discharge precautions when you handle
computer components. Wear an antistatic wrist strap that touches your bare
skin and connect the strap cable to an earth ground. See “Protecting
against Damage from Electrostatic Discharge” in Chapter 4, ‘‘Getting Inside
the Computer’’.
The 1.44 Mbyte, 3.5-inch diskette drive is located in Bay 4 of the peripheral bay,
as shown in Figure 7-1
. There are no jumpers associated with the diskette drive
used in the MAP/5P.
NOTE:
If you are replacing the diskette cable, you must remove the riser card. See
“Riser Card Replacement
” below for the procedure.
Diskette Drive Removal
To remove the diskette drive, you must:
■ Remove the Lucent INTUITY system from service.
■ Access the diskette drive.
■ Extract the diskette drive.