Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing Other Components
Page 7-8CMOS Battery Replacement
7
Removing the Lucent INTUITY System from
Service
To remove the Lucent INTUITY system from service, do the following:
1. Verify that the replacement equipment is on site and appears to be in
usable condition, with no obvious shipping damage.
2. Stop the voice system. See “Stopping the Voice System
” in Chapter 3,
‘‘Common System Procedures’’, for the procedure.
3. Shut down the voice system. See “Shutting Down the Lucent
Intuity
System” in Chapter 3, ‘‘Common System Procedures’’, for the procedure.
4. Remove the incoming power. See “Removing Power from the MAP/5P
” in
Chapter 4, ‘‘Getting Inside the Computer’’
, for this procedure.
Accessing the CMOS Battery
To access the CMOS battery, remove the dress cover. See “Removing the Dress
Cover” in Chapter 4, ‘‘Getting Inside the Computer’’, for this procedure.
Extracting the CMOS Battery
To extract the CMOS battery, do the following:
1. Gently push the battery to the side, away from the rear of the MAP/5P, until
it has cleared the retaining bracket.
2. Pull the battery from the motherboard.
CMOS Battery Installation
To install the CMOS battery, you must:
■ Insert the CMOS battery.
■ Re-assemble the MAP/5P.
■ Restore the Lucent INTUITY system.
■ Verify the CMOS settings.
Inserting the CMOS Battery
To insert the CMOS battery, do the following:
1. Gently push the battery to the side, away from the rear of the MAP/5P, until
it has cleared the retaining bracket.
2. Push the battery into the motherboard.