Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing Other Components
Page 7-6CMOS Battery Replacement
7
protrude from the chassis too far or be recessed into the chassis too
far.
4. Secure the drive in the peripheral bay using the four screws removed in
Step 4
of the procedure, ‘‘Extracting the Cartridge Tape Drive’’, above.
5. Attach the power cable to the cartridge tape drive.
6. Attach the SCSI cable to the cartridge tape drive.
NOTE:
Make sure the SCSI cable pin adapter is attached to the SCSI cable.
Re-assembling the MAP/5P
To re-assemble the MAP/5P, replace the dress cover. See “Replacing the Dress
Cover” in Chapter 4, ‘‘Getting Inside the Computer’’, for this procedure.
Restoring the Lucent INTUITY System
To restore the Lucent INTUITY system, do the following:
1. Restore power to the MAP/5P. See “Restoring Power to the MAP/5P
” in
Chapter 4, ‘‘Getting Inside the Computer’’
, for the procedure.
2. Verify the Lucent I
NTUITY system operation by placing a call to a user.
CMOS Battery Replacement
!
CAUTION:
Observe proper electrostatic discharge precautions when you handle
computer components. Wear an antistatic wrist strap that touches your bare
skin and connect the strap cable to an earth ground. See “Protecting
against Damage from Electrostatic Discharge” in Chapter 4, ‘‘Getting Inside
the Computer’’.
The CMOS battery is located on the motherboard (Figure 7-4).