Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing Other Components
Page 7-5Cartridge Tape Drive Replacement
7
Cartridge Tape Drive Installation
To install a cartridge tape drive, you must:
■ Verify the resource options.
■ Insert the cartridge tape drive.
■ Re-assemble the MAP/5P.
■ Restore the Lucent INTUITY system.
Verifying the Resource Options
To verify the resource options, do the following:
1. Remove the three terminating resistors on the cartridge tape drive
(Figure 7-2
).
2. Verify that the settings are correct (Figure 7-3
).
Figure 7-3. Jumper Settings for the Cartridge Tape Drive, SCSI ID = 3
Inserting the Cartridge Tape Drive
To insert the cartridge tape drive, do the following:
1. Remove the new cartridge tape unit from its ESD-protective wrapping.
NOTE:
Keep the package and all ESD-protective wrapping to return the
defective unit. Re-use of the original replacement unit packaging is
necessary to meet the manufacturer’s warranty.
2. Place the new drive in the Position 1 of the peripheral bay chassis with the
printed circuit board side down.
3. Position the unit so that the cartridge tape drive screw holes line up with
the appropriate holes in the peripheral bay.
NOTE:
Pay close attention to the location of the screws in both the
peripheral bay chassis and the cartridge tape drive. If the screws
are returned to a different position, the cartridge tape drive may