Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing the Hard Disk Drive
Page 6-28Cleaning a Hard Disk Drive
6
Figure 6-17. Disk Cleaning Screen
3. Enter
3
The system displays the following message:
Enter the number of the partition you want to delete
(or enter x to exit)
4. Enter the number of the partition.
For the example given in Figure 6-17
, you would enter
1
The system displays the following message:
Do you want to delete partition
X ? This will erase all
files and programs in this partition (type “y” or “n”).
5. Enter
y
The system displays the following message:
Partition
X has been deleted.
The system displays the Disk Cleaning screen (Figure 6-17
).
6. Enter 4
The system displays the following message:
If you have created or altered a partition, you must
initialize the partition to reflect the new
configuration. For a UNIX System partition run the
Total disk size is 2048 cylinders (2048.0MB)
SELECT ONE OF THE FOLLOWING
0. Overwrite system master boot code
1. Create a partition
2. Change Active (Boot from) partition
3. Delete a partition
4. Update (Update disk configuration and exit)
5. Exit (Exit without updating disk configuration)
Enter selection:
Partition Status Type Start End Length %
Approx
MB
1 Active UNIX
System
0 2047 2048 100 2048.0