Instruction manual

INTUITY Messaging Solutions Release 4

MAP/5P Maintenance

585-310-186

Issue 3

October 1997

Replacing the Hard Disk Drive

Page 6-27Cleaning a Hard Disk Drive

The system displays the Disk Management menu (Figure 6-16).

Figure 6-16. Disk Management Menu

9. Reboot the Lucent I

NTUITY system. See ‘‘Rebooting the System’’ in Chapter

3, ‘‘Common System Procedures’’, for the procedure.

10. Contact the remote maintenance center and ask them to turn on mirroring.

Cleaning a Hard Disk Drive

A hard disk drive which contains data cannot be installed in a Lucent INTUITY

system. The hard disk drive must be cleaned before use. The hard disk drives

can be cleaned:

■ Using the

fdisk

command

■ Performing a low-level format

Using the fdisk Command

To clean a hard disk drive using the fdisk command, do the following:

1. Log in to the system as root.

2. Enter fdisk

/dev/rdsk/c0t1d0s0

CAUTION:

The phrase c0t1d0s0 is the name of the disk to be cleaned. The

phrase c0t1d0s0 is correct for Hard Disk Drive 1. Hard Disk Drive 0

is named c0t0d0s0.

The system displays the Disk Cleaning screen (Figure 6-17).