Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing the Hard Disk Drive
Page 6-26Adding a Hard Disk Drive
6
Figure 6-15. Install Disk Window
6. Enter
1
7. Press (Save).
The system displays the following message:
clean
Install Disk Operation In Progress.
This operation will require approximately 10 minutes
per gig to complete.
The disk install was successful
Press Enter to continue.
If you entered a hard disk drive that is not brand new, the system displays
the following message:
The disk being installed at the selected jumper id has
been installed previously. It is recommended that only
new disks from the factory be installed on this system.
Any existing data on this disk will be lost if you
continue.
Do you wish to continue hit [y/n], and then hit Enter.
Complete the following Steps a through c.
a. Press y.
The system displays the following message:
Option to auto clean disk not supported in this
version.
You must run the shell command fdisk
/dev/rdsk/c0t1d0s0 and delete any active
partitions.
Hit Enter to continue.
b. Press .
c. Clean the hard disk drive. See ‘‘Cleaning a Hard Disk Drive’’
below
for the procedure.
8. Press .
F3
ENTER
ENTER