Instruction manual

INTUITY Messaging Solutions Release 4

MAP/5P Maintenance

585-310-186

Issue 3

October 1997

Replacing the Hard Disk Drive

Page 6-24Replacing a Hard Disk Drive

Inserting Hard Disk Drive 1

To insert the hard disk drive, do the following:

1. Remove the new hard disk drive from its ESD-protective wrapping.

NOTE:

Keep the package and all ESD-protective wrapping to return the

defective unit. Re-use of the original replacement unit packaging is

necessary to meet the manufacturer’s warranty.

2. Attach the hard disk drive, with the component side down, to the

peripheral frame using the four screws removed in Step 6

of “Extracting

Hard Disk Drive 1” above.

NOTE:

Pay close attention to the location of the screws in both the

peripheral frame and the hard disk drive.

3. Attach the power cable to the hard disk drive.

4. Attach the SCSI cable to the hard disk drive.

5. Place the front of the peripheral frame into the MAP/5P.

6. Align the peripheral frame so that the bracing lip on the MAP/5P chassis is

below the guide on the peripheral frame (Figure 6-14

Figure 6-14. Installing the Peripheral Frame