Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing the Hard Disk Drive
Page 6-23Replacing a Hard Disk Drive
6
8. Place the hard disk drive assembly, with the printed circuit board facing
up, on an ESD-protected surface.
9. Continue with the next procedure, ‘‘Hard Disk Drive 1 Installation’’
.
Hard Disk Drive 1 Installation
To install Hard Disk Drive 1, you must:
■ Set the jumper settings.
■ Insert the hard disk drive.
Setting the Hard Disk Drive 1 Jumper Settings
Figure 6-12 shows the correct jumper settings for the Seagate hard disk drive
SCSI ID 1.
Figure 6-12. Hard Disk Drive 1 Jumper Settings - Seagate
Figure 6-13
shows the correct jumper settings for the Capricorn hard disk drive
SCSI ID 1.
Figure 6-13. Hard Disk Drive 1 Jumper Settings - Capricorn
SCSI ID 1
jpcvsg1 LJK 07169
7
13
5
7 9 11 13 15 17 19 21 23
SCSI ID
scsi_io1 CJL 060696