Manualshelf

Instruction manual

ManualsBrandsEicon Networks ManualsComputer equipmentC20
211212213214215216217218219220
INTUITY Messaging Solutions Release 4
MAP/5P Maintenance
585-310-186
Issue 3
October 1997
Replacing the Hard Disk Drive
Page 6-22Replacing a Hard Disk Drive
6
Figure 6-11. Removing the Peripheral Frame
4. Pull the peripheral frame toward you (Figure 6-11
).
The frame will rotate toward the front of the MAP/5P until the bracing lip
has been cleared. At this point you can pull the frame out of the MAP/5P.
5. Locate the screws holding Hard Disk Drive 1 to the peripheral frame
NOTE:
Pay close attention to the location of the screws in both the
peripheral frame and the hard disk drive.
6. Holding the rear of the hard disk drive, remove these screws.
7. Remove Hard Disk Drive 1 from the peripheral frame.
1. Press down on thumb tab
2. Rotate frame out of chassis