Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing the Hard Disk Drive
Page 6-21Replacing a Hard Disk Drive
6
Replacing Hard Disk Drive 1
!
CAUTION:
Observe proper electrostatic discharge precautions when you handle
computer components. Wear an antistatic wrist strap that touches your bare
skin and connect the strap cable to an earth ground. See ‘‘Protecting
against Damage from Electrostatic Discharge’’ in Chapter 4, ‘‘Getting Inside
the Computer’’.
Hard Disk Drive 1 Removal
To remove Hard Disk Drive 1, you must:
■ Remove the Lucent INTUITY system from service.
■ Access the hard disk drive.
■ Extract the hard disk drive.
Removing the Lucent INTUITY System from Service
To remove the Lucent INTUITY system from service, do the following:
1. Verify that the replacement equipment is on site and appears to be in
usable condition, with no obvious shipping damage.
2. Stop the voice system. See ‘‘Stopping the Voice System’’
in Chapter 3,
‘‘Common System Procedures’’, for the procedure.
3. Shut down the voice system. See ‘‘Shutting Down the Lucent
Intuity
System’’ in Chapter 3, ‘‘Common System Procedures’’, for the procedure.
4. Remove the incoming power. See ‘‘Removing Power from the MAP/5P’’
in
Chapter 4, ‘‘Getting Inside the Computer’’
, for this procedure.
Accessing Hard Disk Drive 1
To access Hard Disk Drive 1, remove the dress cover. See ‘‘Removing the Dress
Cover’’ in Chapter 4, ‘‘Getting Inside the Computer’’, for this procedure.
Extracting Hard Disk Drive 1
To extract Hard Disk Drive 1, do the following:
1. Remove the SCSI cable from the back of the hard disk drive.
2. Remove the power cord from the back of the hard disk drive.
3. Press down on the thumb-tab which locks the peripheral frame in place
(Figure 6-11
).