Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing the Hard Disk Drive
Page 6-18Replacing a Hard Disk Drive
6
Hard Disk Drive 0 Removal
To remove Hard Disk Drive 0, you must:
■ Remove the Lucent INTUITY system from service.
■ Access the hard disk drive.
■ Extract the hard disk drive.
Removing the Lucent INTUITY System from Service
To remove the Lucent INTUITY system from service, do the following:
NOTE:
This procedure is not necessary if Hard Disk Drive 0 has failed on a
single-disk system.
1. Verify that the replacement equipment is on site and appears to be in
usable condition, with no obvious shipping damage.
2. Stop the voice system. See ‘‘Stopping the Voice System’’
in Chapter 3,
‘‘Common System Procedures’’, for the procedure.
3. Shut down the voice system. See ‘‘Shutting Down the Lucent
Intuity
System’’ in Chapter 3, ‘‘Common System Procedures’’, for the procedure.
4. Remove the incoming power. See ‘‘Removing Power from the MAP/5P’’
in
Chapter 4, ‘‘Getting Inside the Computer’’
, for this procedure.
Accessing Hard Disk Drive 0
To access Hard Disk Drive 0, remove the dress cover. See ‘‘Removing the Dress
Cover’’ in Chapter 4, ‘‘Getting Inside the Computer’’, for this procedure.
Extracting Hard Disk Drive 0
To extract Hard Disk Drive 0, do the following:
1. Remove the SCSI cable from the back of the hard disk drive.
2. Remove the power cord from the back of the hard disk drive.
3. Locate the screws holding Hard Disk Drive 0 to the peripheral bay frame
NOTE:
Pay close attention to the location of the screws in both the
peripheral frame and the hard disk drive.
4. Holding the rear of the hard disk drive, remove these screws.
5. Place the hard disk drive assembly, with the printed circuit board facing
up, on an ESD-protected surface.
6. Continue with the next procedure, ‘‘Hard Disk Drive 0 Installation’’
.