Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing the Hard Disk Drive
Page 6-13Recovering from a Hard Disk Drive 0 Failure
6
5. Change the jumpers on the hard disk drive to the correct positions for
Hard Disk Drive 0. See ‘‘Setting the Hard Disk Drive 0 Jumper Settings’’
below for the procedure.
6. Place this hard disk drive in Bay 5. See ‘‘Inserting Hard Disk Drive 0’’
below for the procedure.
7. Place this hard disk drive in Bay 6. See ‘‘Inserting Hard Disk Drive 1’’
below for the procedure.
Restoring the Lucent INTUITY System
To restore the Lucent INTUITY system, do the following:
1. Restore power to the MAP/5P. See ‘‘Restoring Power to the MAP/5P’’
in
Chapter 4, ‘‘Getting Inside the Computer’’
, for the procedure.
2. Inactivate alarm suppression by completing the following Steps a through
d
:
NOTE:
This procedure only applies to systems with alarm origination.
a. Starting at the Lucent I
NTUITY Main menu (Figure 6-1), select
The system displays the Alarm Management window (Figure 6-4
).
b. Move the cursor to the
Alarm Suppression
field and type
inactive
c. Press (Save).
The system displays the Information window (Figure 6-5
).
d. Press .
> Alarm Management
> Customer/Services Administration
F3
ENTER