Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing the Hard Disk Drive
Page 6-12Recovering from a Hard Disk Drive 0 Failure
6
will be lost if you continue.
Do you wish to continue hit [y/n], and then hit
Enter.
Complete the following Steps a through c:
a. Press y.
The system displays the following message:
Option to auto clean disk not supported
in this version.
You must run the shell command fdisk
/dev/rdsk/c0t1d0s0 and delete any active
partitions.
Hit Enter to continue.
b. Press
.
c. Clean the hard disk drive. See ‘‘Cleaning a Hard Disk Drive’’
below for the procedure.
d. Return to Step 1 above.
5. Press when the system displays the following message:
Disk replace was successful
Hit Enter to continue.
NOTE:
At this point the mirroring has been completed and the information has
been restored to Hard Disk Drive 0.
Restoring the SCSI IDs
In “Replacing the Hard Disk Drive” you were instructed to change the jumper
settings and positions for the hard disk drives. In this procedure you will switch
the jumper settings and hard disk drives again so that the original Hard Disk
Drive 1 has been restored to its correct position and the new hard disk drive
becomes Hard Disk Drive 0.
To restore the SCSI IDs for the hard disk drives, do the following:
1. Remove the hard disk drive from Bay 5. See ‘‘Hard Disk Drive 0 Removal’’
below for the procedure.
2. Change the jumpers on the hard disk drive to the correct positions for
Hard Disk Drive 1. See ‘‘Setting the Hard Disk Drive 1 Jumper Settings’’
below for the procedure.
3. Place the hard disk drive to the side.
4. Remove the hard disk drive from Bay 6. See ‘‘Hard Disk Drive 1 Removal’’
below for the procedure.
ENTER
ENTER