Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing the Hard Disk Drive
Page 6-11Recovering from a Hard Disk Drive 0 Failure
6
■ If the disk name and jumper id you entered match those of the
failed disk drive, the system displays the following message:
This operation will require approximately 10
minutes per gig to complete.
Continue with Step 5 below.
■ If you entered a disk name and/or jumper id that does not exist on
the system, the system displays the following message:
Error: disk at selected jumper id not found.
Make sure disk is physically installed properly.
Hit Enter to continue.
The disk name you enter must be the same as the old
(failed) disk’s name. The jumper id must match
the jumper settings on the disk with the above
specified name. Therefore, you entered either the
disk name and/or jumper id incorrectly on the
Replace Disk screen, or you incorrectly set the
jumpers on the disk.
Press , return to the appropriate step in
this procedure, and correct the mismatch.
Verify the hard disk drive installation was done correctly.
■ If you entered a disk name and jumper id for a disk other than the
one being replaced, the system displays the following message:
The selected disk appears to be ok. Make sure
correct disk name and jumper id were entered on
the disk replace screen.
Hit Enter to continue
The disk name you enter must be the same as the old
(failed) disk’s name. The jumper id must match
the jumper settings on the disk with the above
specified name. Therefore, you incorrectly
entered the disk name and/or jumper id on the
Replace Disk screen.
Press , return to the appropriate step in
this procedure, and correct the mismatch.
Verify the disk name and jumper id that you copied in Step 9 above.
■ If you entered the correct disk name and jumper id but the disk that
was installed is not brand new, the system displays the following
message:
The disk being installed at the selected jumper id
has been installed previously. It is recommended
that only new disks from the factory be installed
on this system. Any existing data on this disk
ENTER
ENTER