Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing the Hard Disk Drive
Page 6-10Recovering from a Hard Disk Drive 0 Failure
6
6. Place the new hard disk drive in the position reserved for Hard Disk Drive
1. See ‘‘Inserting Hard Disk Drive 1’’
below for the procedure.
NOTE:
This drive is now Hard Disk Drive 1.
7. Reboot the Lucent I
NTUITY system. See ‘‘Rebooting the System’’ in Chapter
3, ‘‘Common System Procedures’’, for the procedure.
Initializing the New Hard Disk Drive 0
To initialize the hard disk drive, do the following:
1. Starting at the Lucent I
NTUITY Main menu (Figure 6-1), select
The system displays the Replace Disk window (Figure 6-6
).
Figure 6-6. Replace Disk Window
2. In the Enter the logical name of the disk: field, enter Disk 0
3. In the Enter jumper id of the disk being replaced (0-7):
field, enter 1
4. Press (Save).
>Replace Disk
> Disk Management
>
System Management
> Customer/Services Administration
F3