Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing the Hard Disk Drive
Page 6-7Recovering from a Hard Disk Drive 0 Failure
6
10. Install the Lucent INTUITY System Default Announcement set and/or
Optional Language Package Announcement sets software. See ‘‘Installing
the Lucent Intuity System Default Announcement Set and/or Optional
Language Package Announcement Sets’’ in Chapter 9, ‘‘Installing
Lucent™ Intuity™ System Software’’.
11. Load RFU Software Update cartridge tape if any. Contact the remote
maintenance center for the identity of the current RFU. See Chapter 11,
‘‘Installing an RFU’’.
12. Reboot the system. See ‘‘Rebooting the System’’
in Chapter 3, ‘‘Common
System Procedures’’.
13. Configure the LAN circuit card. See ‘‘Configuring the LAN Circuit Card’’
in
Chapter 5, ‘‘Replacing or Installing Circuit Cards’’
.
14. Restore the system from the nightly backup tape. See ‘‘Restoring
Backups’’ in Chapter 3, ‘‘Common System Procedures’’.
15. Press
(Cancel) three times to return to the Console Login prompt.
16. Login as tsc.
17. Insert the attended backup tape. See ‘‘Inserting the Cartridge Tape’’
in
Chapter 3, ‘‘Common System Procedures’’
, for the procedure.
18. Enter
/mtce/bin/ldvoice1 2>1 | tee /tmp/ldvoice1.out
This command will restore the names and announcements. In addition,
this command will restore any greetings and messages which were stored
in the /voice1 file system on Hard Disk Drive 0 at the time of the full
attended backup.
19. Enter
/vs/bin/util/rcvrv1
This command will rename the file
/snap/installit.vs
to
/snap/recovered.inf.
This takes the system out of the disaster recovery
state.
20. Enter
exit
The system displays the console login prompt.
21. Login to the system as craft.
22. Start the voice system. See ‘‘Starting the Voice System’’
in Chapter 3,
‘‘Common System Procedures’’, for the procedure.
F6