Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing the Hard Disk Drive
Page 6-6Recovering from a Hard Disk Drive 0 Failure
6
Recovering from a Hard Disk Drive 0
Failure
The following sections list the procedures for recovering from a Hard Disk Drive 0
failure in both single disk and mirrored systems.
Recovering from a Hard Disk Drive 0 Failure in a
Single Disk System
Because Disk 0 contains the base system software, you must reinstall the entire
Lucent I
NTUITY system if this disk fails on a single disk system. To recover from a
Hard Disk Drive 0 failure in a single disk system, do the following:
1. Replace the hard disk drive. See ‘‘Replacing Hard Disk Drive 0’’
below for
the procedure.
!
CAUTION:
After installing a 2-Gbyte hard disk drive into a system as Disk 0,
DO
NOT ATTEMPT TO INSTALL AN OLDER VERSION OF UNIXWare
.
The version of the operating system tape that should be used
contains the phrase “Independent Image.” If the operating system
tape does not contain this phrase, notify the remote maintenance
center immediately.
2. Verify the CMOS settings. See ‘‘Verifying the CMOS Settings’’ in Chapter 7,
‘‘Replacing Other Components’’.
3. Verify the SCSI host adapter settings. See ‘‘SCSI Controller Circuit Card’’
in
Chapter 5, ‘‘Replacing or Installing Circuit Cards’’
.
4. Low level format the hard disk drive. See ‘‘Performing a Low-Level Format’’
in Chapter 6, ‘‘Replacing the Hard Disk Drive’’
.
5. Reinstall the base system software. See ‘‘Installing UnixWare’’
and
“Installing the Platform Software
” in Chapter 8, ‘‘Installing Base System
Software’’, for the procedure.
6. Install the INTUNIX+e update package. See ‘‘Installing the INTUNIX+e
Software’’ in Chapter 8, ‘‘Installing Base System Software’’.
7. Install the AUDIX® software. See ‘‘Installing the Platform Software’’
in
Chapter 8, ‘‘Installing Base System Software’’
.
8. Install the DCIU software. See ‘‘Installing the DCIU Switch Integration Set’’
in Chapter 8, ‘‘Installing Base System Software’’
.
9. Install the Lucent I
NTUITY AUDIX Voice Messaging System software. See
‘‘Installing the
Intuity AUDIX Voice Messaging System’’ in Chapter 9,
‘‘Installing Lucent™ Intuity™ System Software’’.