Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing or Installing Circuit Cards
Page 5-46Installing a Remote Maintenance Circuit Card, Version 2
5
Figure 5-33. Motherboard Cable Connections
Restoring the System
To restore the system, do the following:
1. Replace all cables removed from other cards. Make sure these cables are
attached to their proper terminations.
2. Close the computer.
3. Reboot the voice system.
Verifying the Installation
To verify the installation of the circuit card, do the following:
1. Starting at the Lucent™ I
NTUITY™ Main menu (Figure 5-27), select
1. RMB reset cable connector (pins 1 and 2 of CN30)
2. Reset switch connector (pins 19 and 20 of CN19)
3. Turbo LED connector (pins 12 and 13 of CN19)
4. Power LED connector (pins 3,4, and 5 of CN19)