Instruction manual

INTUITY Messaging Solutions Release 4

MAP/5P Maintenance

585-310-186

Issue 3

October 1997

Replacing or Installing Circuit Cards

Page 5-12Circuit Card Settings

3. Install the DCIU circuit card. See “Installing a Circuit Card” for the

procedure.

4. Reboot the Lucent I

NTUITY system. See ‘‘Rebooting the System’’ in Chapter

3, ‘‘Common System Procedures’’, for the procedure.

Digital Station Interface Circuit Card

The digital station interface circuit card (Figure 5-7) connects to Lucent switches.

Your system may interface with the switch through this circuit card.

NOTE:

In order to use this circuit card the Digital Station Circuit Card Switch

Integration set must be installed on the Lucent I

NTUITY system. See

‘‘Installing the Digital Station Interface Circuit Card Switch Integration Set’’

in Chapter 8, ‘‘Installing Base System Software’’

, for the procedure.

You can install only one digital station interface circuit card in the MAP/5P.