Instruction manual

INTUITY Messaging Solutions Release 4

MAP/5P Maintenance

585-310-186

Issue 3

October 1997

Replacing or Installing Circuit Cards

Page 5-10Circuit Card Settings

Figure 5-5. Switch Settings for the MAP/5P ACCX Circuit Card

See ‘‘General Procedures’’

above for the ACCX circuit card installation

procedure.

Switch Interface Circuit Cards

The Lucent INTUITY system interfaces with the customer switch through:

■ DCIU circuit card

■ Digital station interface circuit card

DCIU Circuit Card

The DCIU circuit card (Figure 5-6) connects to Lucent switches through an X.25

link. Your system may interface with the link through this circuit card.

NOTE:

In order to use this circuit card the DCIU Switch Integration set must be

installed on the Lucent I

NTUITY system. See ‘‘Installing the DCIU Switch

Integration Set’’ in Chapter 8, ‘‘Installing Base System Software’’, for the

procedure.

Base I/O address = 140 hex

ACCX (AYC22) Card #1

Bas