Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing or Installing Circuit Cards
Page 5-7Circuit Card Settings
5
Multi-Port Serial Circuit Card
The multi-port serial circuit card for the MAP/5P (Figure 5-3) has eight serial
ports. Each port is a 6-wire, RJ-11 modular jack.
Modular adapters convert the modular jacks to RS-232 connectors. You need
one adapter for each device to be connected. All eight serial ports can be used
for modem, terminal, or other DTE or DCE components, provided they are not
being used for switch integration.
You can install only one multi-port serial circuit card in the MAP/5P.
Figure 5-3. Multi-Port Serial Circuit Card
The multi-port serial circuit card requires no hardware configuration. Verify that
no jumpers are set on this circuit card.
See “General Procedures
” above for multi-port serial circuit card installation
procedure.
ttysaa
ttysab
ttysac
ttysad
ttysae
ttysaf
ttysag
ttysah
Do not use
jumpers
Each port is a
6wireRJ-11jack