Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Replacing or Installing Circuit Cards
Page 5-6Circuit Card Settings
5
Figure 5-2. View Installed Hardware Window
c. Verify that the system has identified the new circuit card.
Circuit Card Settings
The following sections list the specific jumper and switch settings for optional
circuit cards.
!
CAUTION:
Observe proper electrostatic discharge precautions when you handle
computer components. Wear an antistatic wrist strap that touches your bare
skin and connect the strap cable to an earth ground. See “Protecting
against Damage from Electrostatic Discharge” in Chapter 4, ‘‘Getting Inside
the Computer’’.
This section provides the following information on the optional feature circuit
cards:
■ Switch and jumper settings
■ Other installation requirements that are specific to the particular circuit
card you are installing
In general, circuit cards are not preset at the factory. You must set the switches
and jumpers (resource options)
before you install the circuit cards. When you set
the switches according to the instructions in this book, remember that OFF is
equivalent to open and ON is equivalent to closed.