Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Getting Inside the Computer
Page 4-6Removing the Dress Cover
4
1. Shut down the Lucent™ INTUITY™ system. See “Shutting Down the Lucent
Intuity System” in Chapter 3, ‘‘Common System Procedures’’, for the
procedure.
2. Turn off the monitor’s power switch.
The green or amber lamp on the front bottom of the monitor should be off.
3. Turn off the power switch on the front of the MAP/5P.
The green lamp labeled POWER ON on the front of the unit should be off.
4. Unplug the MAP/5P from the power outlet.
5. Remove the MAP/5P power cord from the AC receptacle in the wall.
6. Observe the correct lock-out/tag-out precautions for isolating power as
outlined in the Lucent lock-out/tag-out procedure.
Removing the Dress Cover
The dress cover provides protection for the internal components of the MAP/5P.
You must remove the dress cover to access these components.
!
DANGER:
Shut power off before removing the dress cover. See ‘‘Removing Power
from the MAP/5P’’, above for the procedure.
To remove the dress cover, do the following:
1. Place the dress cover lock (Figure 4-5
) in the open position.
NOTE:
Figure 4-5 shows the dress cover lock in the locked position.
2. Simultaneously compress the dress cover latches on either side of the
MAP/5P (Figure 4-6
).
3. Slide the dress cover away from the MAP/5P.