Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Common System Procedures
Page 3-27Shutting Down and Rebooting the Lucent I NTUITY System
3
Rebooting the System
Rebooting the system can be done in two ways:
■ A warm reboot (performed while the computer is on)
■ A cold reboot (turning the computer off, then back on again)
Performing a Warm Reboot
1. Make sure that there is no diskette in the floppy drive.
2. Press .
The system performs a power-on self test (POST). The screen lists various
hardware components and the status of the tests performed on those
components.
When the reboot is complete, the system displays the following prompt:
Startup of the Voice System is complete.
Console Login:
3. If
FAIL
appears in the status column for any component do the following:
a. Record the component’s name.
b. Access the alarm log to begin troubleshooting. See Chapter 1,
“Getting Started,” in
Lucent I NTUITY Alarms and Log Messages for
this procedure.
Performing a Cold Reboot
1. Make sure that there is no diskette in the floppy drive.
2. To perform a cold reboot, turn the MAP/5P off by pressing the power
button on the front of the unit (Figure 3-3
).
3. Wait 30 seconds to allow the drives to come to a complete stop.
4. Turn the power on by pressing the power button on the front of the MAP/5P
(Figure 3-3
).
Ctrl-Alt-Del