Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Common System Procedures
Page 3-23Administering Voice Messaging
3
11. Press when the restore is complete.
The system displays the following message:
restore process has been completed successfully
press any key to continue
If the restore fails, the system displays the following message:
Restore Failed
.
Do the following:
a. Rewind the tape by removing it from the tape drive and then
reinserting it.
b. Return to Step 4 and attempt the restore again.
c. If the restore fails a second time, access the alarm log. See Chapter
1, “Getting Started,” in
Lucent I NTUITY Alarms and Log Messages
and follow associated repair actions for any active alarms in the
log.
12. Reboot the system. See “Shutting Down and Rebooting the Lucent
Intuity
System” below for this procedure.
Administering Voice Messaging
The voice system is the Lucent INTUITY system’s base voice processing software.
Starting the voice system brings the software into a state where it can accept and
process calls. Stopping the voice system brings the software into a lower level
state in which it cannot accept calls.
Starting the Voice System
To start the voice system, do the following:
1. Starting at the Lucent I
NTUITY Main menu (Figure 3-1), select
ENTER
>Start Voice System
> System Control
> System Management
> Customer/Services Administration