Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Common System Procedures
Page 3-21Restoring Backups
3
When the backup is complete, the system displays the following message:
backup process has been completed successfully
press any key to continue
10. Press .
Restoring Backups
The information stored on cartridge tapes during the unattended and attended
backup procedures is used to restore the system to an operational state.
If a system problem or failure occurs, backups can be invaluable in returning the
system to an operational state. You will likely only restore backups when directed
to do so by an alarm repair action.
Depending on the severity of the situation, Lucent I
NTUITY software may have to
be reinstalled before restoring any backups. See Chapter 9, ‘‘Installing Lucent™
Intuity™ System Software’’, for these procedures.
NOTE:
It takes approximately 2 hours to restore one tape.
This procedure works for both attended and unattended backups.
To restore the backup, do the following:
1. Stop the voice system. See “Stopping the Voice System
” below for more
information.
2. Starting at the Lucent I
NTUITY Main menu (Figure 3-1), select
The system displays the following message:
please insert a tape into the tape drive to restore
press <Enter> when tape is inserted
press <Esc> key to terminate the restore
3. Insert the cartridge tape that contains the data to be restored into the tape
drive. See “Inserting the Cartridge Tape
” above for more information.
4. Press to continue.
ENTER
>
Restore
> Backup/Restore
> Customer/Services Administration
ENTER