Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Common System Procedures
Page 3-20Backing Up (Attended)
3
5. Make sure that there are enough cartridge tapes to accommodate the
backup.
The system displays the following message:
Verify whole backup tape(s) will double the amount of
backup time.
Do you really want to verify tape(s)?
(Strike y or n)
6. The Lucent I
NTUITY system verifies a backup tape by reading back the
entire set of data it has just written on the tape.
NOTE:
Verifying the back-up tape increases the total time for backup from
1-1/2 hours to 3 hours. Verification is not necessary to ensure a good
back-up tape.
To verify the back-up tape, press
y
. If you do not want to verify the backup
tape, press
n
.
The system displays the following message:
please insert a tape into the tape drive to back up
tape 1
press <Enter> when tape is inserted
press <Esc> key to terminate the backup
7. Insert the first cartridge tape in the tape drive. See “Inserting the Cartridge
Ta p e ” above for this procedure.
8. Press when the tape drive is idle.
The system displays a series of messages indicating what is being stored
on the backup tape.
NOTE:
The light on the 2-Gbyte drive will blink when the drive is in use. If the
light is not blinking, the tape drive is idle.
9. If another tape is necessary:
a. Remove the current tape. See “Removing the Cartridge Tape
”
above for this procedure.
b. Label the tape with the current date and back-up data type(s).
c. Insert the next tape. See “Inserting the Cartridge Tape
” above for
this procedure.
If another tape is not necessary, continue with Step 10.
ENTER