Instruction manual

INTUITY Messaging Solutions Release 4
MAP/5P Maintenance 585-310-186
Issue 3
October 1997
Common System Procedures
Page 3-8About Diskette Drives and Diskettes
3
Removing the Diskettes
To remove a diskette, do the following:
!
CAUTION:
You can only remove the diskette when the drive is idle, that is, when the
light is not on.
1. Press the button on the lower right corner of the diskette drive to reveal
part of the diskette.
2. Pull out the diskette.
Formatting Diskettes
Formatting prepares a diskette to receive data. To format a diskette, do the
following:
1. Starting at the Lucent I
NTUITY Main menu (Figure 3-1), select
The system displays the Format UNIX Floppy/Tape menu (Figure 3-5
).
2. Select
Format 3.5 inch 1.44 Mbyte (High Density)
or
Format
3.5 inch 720 Kbyte (Low Density)
depending on the type of
diskette being used.
3. Verify that the diskette is not write-protected and insert the tape into the
tape drive. See “Inserting the Diskettes
” above for more information.
4. Press y
The system displays a screen stating that the diskette has been formatted.
5. Remove the diskette from the diskette drive.
6. Press .
>Format UNIX Floppy/Tape
> UNIX Management
> System Management
> Customer/Services Administration
ENTER